Essays about: "power amplifier design"

Showing result 1 - 5 of 96 essays containing the words power amplifier design.

  1. 1. Digital Front End Algorithms for Sub-Band Full Duplex

    University essay from Lunds universitet/Institutionen för elektro- och informationsteknik

    Author : Midhat Rizvi; Khaled Al-Khateeb; [2023]
    Keywords : Adjacent Channel Leakage Ratio; Bit Error Rate; Clipping and Filtering; Crest Factor Reduction; Digital front end; Digital Pre-Distortion Error Vector Magnitude; Frequency Division Duplex; Power Amplifier; Peak to Average Power Ratio; Peak Cancellation Crest Factor Reduction; Sub Band Full Duplex; Self-Interference Cancellation; Signal-to-Interference Noise Ratio; Signal-to-Noise Ratio; Turbo Clipping; Time Division Duplex; Technology and Engineering;

    Abstract : Sub-band full duplex is a new communication scheme technology, where a single frequency band is partitioned into sub-bands for downlink (DL) and up-link(UL) transmissions, and both can take place simultaneously. The idea behind the sub-band full duplex development is to improve the throughput, and coverage and reduce the latency of the UL communication by allowing the UL reception during the DL transmission. READ MORE

  3. 2. Simulation, Design, and Implementation of a Narrow Linewidth Ytterbium Fiber MOPA System at 1087 nm

    University essay from KTH/Tillämpad fysik

    Author : Berkay Efilti; [2023]
    Keywords : Applied Physics; Laser Physics; Fiber Lasers; Fiber Amplifiers;

    Abstract : This thesis focuses on simulating, designing, and characterizing a narrow-linewidth continuous-wave (CW) Ytterbium (Yb) master oscillator fiber amplifier (MOFA) system. The primary goal was to achieve a watt-level output at 1087 nm with a narrow 1 GHz linewidth, making the MOFA well-suited for serving as a pump source in Terahertz (THz) generation experiments. READ MORE

  4. 3. Current-Mode Class D Power Amplifier for 2.4GHz Wi-Fi

    University essay from KTH/Skolan för elektroteknik och datavetenskap (EECS)

    Author : Yann Jean Michael Pirot; [2023]
    Keywords : Power Amplifier; Wifi; Digital Power Amplfier; Class D; RFIC; Analogue; Effektförstärkare; Wifi; digital förstärkare; klass D; analog;

    Abstract : Modern wireless communication techniques employed in the Wi-Fi® protocol, such as orthogonal frequency-division multiplexing exhibit analogue signals with high peak-to-average power ratio. Therefore, power amplifiers for Wi-Fi suffer from low efficiency when operating in back-off mode, away from their maximum efficiency at peak power. READ MORE

  5. 4. An amplitude modulated laser rangefinder : electronic circuit design and implementation

    University essay from Uppsala universitet/Signaler och system

    Author : Fazel Naser; Stefan Morin; [2022]
    Keywords : Amplitude modulation; Phase shift; Laser rangefinder; Drive electronics; PCB; Colpitts crystal oscillator; Transimpedance amplifier;

    Abstract : This report describes the design and implementation of a prototype for an amplitude modulated laser rangefinder, which is made on a PCB consisting of a laser module emitting light, a photodiode receiving the light reflected from the target, and other components. The design is made for the different power levels, generation of the modulation output and the reception of the signal. READ MORE

  6. 5. E-Band SPDT RF Switch for a Class F PA in III-V Nanowire MOSFET Technology

    University essay from Lunds universitet/Institutionen för elektro- och informationsteknik

    Author : Rungeng Xu; [2022]
    Keywords : E-band; III-V Nanowire MOSFET; RF Switch; Class-F PA; Technology and Engineering;

    Abstract : This project designs an RF switch operating in E-band to provide a transmit path from a Class-F power amplifier (PA). The basic RF switch is based on the single-pole double-throw (SPDT) topology using shunt transistor switches and two λ/4 transmission line. READ MORE