Macro composites for crushing - additive manufacturing of hard phase : Development and testing of macro composites for crushing purposes

Abstract: During this master thesis a crushing material composite was developed in order to determine if a specific design consisting of a pointy hard phase with a ductile phase in between can reduce the load needed to crush stone and therefor decrease the energy consumption during stone crushing. The steel hard phase (ASP 2012) was printed using an additive manufacturing method called selective laser melting (SLM). A process parameter optimization was performed in order to achieve a dense material and a pre-heated building platform was used to prevent cracking. The hard phase designs were printed and then filled with bronze (JM3 and JM7). The composites and steel references were tested by placing a stone on each sample and applying pressure until the stone broke. After the tests, the loads and the deterioration of the samples was analyzed. The results showed that it was possible to print the hard phase, but some defects like micro cracking were hard to eliminate entirely. Several methods were tested to cast the bronze but the most suitable during this project was melting of the bronze in an induction furnace with vacuum atmosphere. The results from the crushing simulations showed that there was a small difference between the references and the developed macro composites. The composites began to crush stones at lower loads than the references. Nevertheless, due to a large dispersion of the results a statistical difference could not be established.