Purification and surface modification of polymeric nanoparticles for medical applications

Abstract: Polymeric nanoparticles are potential candidates as carriers for pharmaceutical agents. Development of such nanoparticles generally requires molecules immobilized on the particle surfaces to ensure biocompatibility and/or targeting abilities. Following particle preparation and surface modification, excess reagents must be removed. Ultracentrifugation, which is the most widely used purification technique as per today, is not feasible in industrial applications. In this diploma work, tangential flow filtration is studied as an alternative purification method which is better suited for implementation in a large-scale process. Comparison of ultracentrifugation and tangential flow filtration in diafiltration mode for purification of nanoparticles, indicate that they are comparable with respect to particle stability and the removal of the surfactant SDS from methacrylic anhydride nanoparticles. The purification efficiency of tangential flow filtration is superior to that of ultracentrifugation. Conductivity measurements of filtrates and supernatant liquids show that a stable conductivity value can be reached 6 times faster in filtration than in centrifugation with equipment and settings used. This conductivity arises from several types of molecules, and the contribution from surfactant molecules alone is not known. However, protein adsorption on the particles indicates successful removal of surfactant. Conductivity and tensiometry were evaluated as potential methods to quantify surfactant in solutions, but both proved unsatisfactory. Using bovine serum albumin as a model protein, the extent of immobilization to nanoparticles is evaluated at different pH. A maximum amount of 6,8 mg/m2 is immobilized, whereof an unknown part is covalently bound. This coverage is achieved at pH 4,0 and is probably partly due to low electrostatic repulsion between particle and protein. An estimation of 2,0 µmol covalently bound BSA per gram of nanoparticles corresponds to 5,3 mg/m2 and a surface coverage of 76%. Removal of excess reagents after surface modification is done with ultracentrifugation instead of filtration, as particle aggregates present after the immobilization reaction might foul the membrane.