A Study of Different Switched Mode Power Amplifiers for the Burst Mode Operation

Abstract: Power-amplifier efficiency is a significant issue for the overall efficiency of most wireless system. Therefore, currently there are different kind of Switched mode power amplifiers are developed which are showing very high efficiency also at higher frequencies but all of these amplifiers are subjected to drive with the constant envelope signals. Whereas, for the increasing demand of high data rate transmissions in wireless communication there are some new modulation schemes are introduced and which are generating no more a constant envelope signal but a high peak to average power signal. Therefore, recently a new technique is proposed called the burst mode operation for operating the switched mode power amplifiers efficiently while driven by a high peak to average power signal.   The purpose of this master thesis work was to review the theory of this burst mode operation and some basic investigations of this theory on switched mode power amplifiers were performed in simulation environments. The amplifiers of class D, inverse D, DE and J are studied. The thesis work was mainly carried out by ADS and partly in MATLAB SIMULINK environment. Since this burst mode operation is a completely new technique therefore a new Harmonic balance simulation setups in ADS and Microwave Office are developed to generate the RF burst signals.   A Class J amplifier based on LDMOS technique is measured by a 16 carrier multi-tone signal having peak to average power ratio of 7 dB and achieved the drain efficiency of 50% with -30 dBc linearity at 946 MHz.