Essays about: "Analog elektronik"
Showing result 1 - 5 of 27 essays containing the words Analog elektronik.
-
1. A Low Noise Digitally Controlled Oscillator for a Wi-Fi 6 All-Digital PLL
University essay from KTH/Skolan för elektroteknik och datavetenskap (EECS)Abstract : Following the rise of Internet of Things (IoT), or just the technological advancements and expectations in a world where the things are or will be connected, new demands are put on Integrated Circuit (IC) for wireless connectivity. The use cases seem endless; smart home, healthcare, entertainment, and science are all areas that can benefit from connectivity of low power electronics. READ MORE
-
2. Design of auxiliary communication for audio between computers and DSPs : Programming and optimization of computational resources
University essay from Umeå universitet/Institutionen för tillämpad fysik och elektronikAbstract : This thesis report is about designing a prototype and establishing audio communication between a computer and Digital Signal Processor (DSP) using two preamp circuits using both auxiliary and USB connection. The paper gives the reader an overview on how audio is transmitted from a computer, through the system and to the desired output. READ MORE
-
3. PCBA verification and fault detection using a low-frequency GMR-based near-field probe with magnetic closed-loop feedback compensation : A non-contact alternative to physical probing
University essay from KTH/Skolan för elektroteknik och datavetenskap (EECS)Abstract : As electronics are getting both smaller and more advanced, the need to verify and validate remains and the means are getting more complex the more functions and components are added. Traditionally, in-circuit tests (ICTs) are performed by probing dedicated test points on the Printed Circuit Board Assembly (PCBA) in a test sequence that is unique to each product. READ MORE
-
4. Methods to simulate resistance at high resolution and accuracy
University essay from Uppsala universitet/ElektricitetsläraAbstract : In this paper, four methods to simulate or generate electric resistance at high resolution have been developed, tested and evaluated. Each method is called a Resistor Simulator and are numbered from one to four. READ MORE
-
5. Analog Front End Development for the Large Hadron Collider Interlock Beam Position Monitor Upgrade
University essay from KTH/Skolan för elektroteknik och datavetenskap (EECS)Abstract : The interlock Beam Position Monitor (BPM) system in the Large Hadron Collider(LHC) is responsible for monitoring the particle beam position at the point of thebeam dump kicker magnets and is part of the machine protection system. Thecurrent interlock BPM system has some limitations and because of this, an upgradeproject has been initiated. READ MORE