Essays about: "Powder metallurgy PM"

Showing result 1 - 5 of 9 essays containing the words Powder metallurgy PM.

  1. 1. Friction and wear study of lean powder metallurgy steel in a lubricated sliding contact

    University essay from Uppsala universitet/Tillämpad materialvetenskap

    Author : Caroline Lejonklo; [2019]
    Keywords : Lean steel; Powder metallurgy PM ; Powder metallurgy steel PM steel ; Friction; Wear; Sliding contact; Lubricated; Porosity; Tribology; Adhesive wear; Abrasive wear; Gear; Gear tooth; Particles; Polyalphaolefin 8 PAO 8 ; Contact pressure; Density; Light optical microscopy LOM ; Scanning electron microscopy SEM ; Energy-dispersive X-ray spectroscopy EDS ; Vertical svanning interferometry VSI ; Pin on disc; Pin-on-disc;

    Abstract : A fairly new technology used to produce metallic components is powder metallurgy (PM). Among the advantages with this technique are decreased cost of production for complex-shaped parts, new alloys are made possible, reduced end processing, less material loss, and vibrational damping effects. READ MORE

  3. 2. Modelling the influence of porosity on fatigue strength of sintered steels

    University essay from Uppsala universitet/Strukturkemi

    Author : Emily Hall; [2019]
    Keywords : Fatigue; Powder metallurgy; PM; sintered steels; fracture mechanics; porosity; metal powders; fatigue strength; fatigue limit; utmattning; pulvermetallurgi; metallpulver; utmattningsgräns; brottmekanik; porositet; sintring;

    Abstract : The pores in pressed and sintered components constitute weak points in the material since the stress concentration is larger than the nominal stress there. Therefore, fatigue cracks initiate at the pores. Specifically, it can be assumed that the fatigue cracks initiate at the largest pore in the stressed volume. READ MORE

  4. 3. Evaluation of Different Concepts for Pressed and Sintered Connecting Rods

    University essay from Luleå tekniska universitet/Institutionen för teknikvetenskap och matematik

    Author : Mattias Rehn; [2019]
    Keywords : Connecting Rod; Con Rod; Fatigue; Buckling; Manufacturing; Höganäs AB; CAD; FEM; FEA;

    Abstract : Connecting rod are found in most combustion engines and transmits thrust from the piston to the crankshaft. The connecting rod needs to withstand forces from the piston and inertia forces which results in axial tension, compression stresses and bending. READ MORE

  5. 4. In-situ Reduction by Incorporating H2 Filled Hollow Glass Microspheres in PM HIP Capsules

    University essay from KTH/Materialvetenskap

    Author : Emil Strand; [2018]
    Keywords : Hot isostatic pressing; hollow glass microspheres; powder metallurgy; oxide reduction; surface oxides; hydrogen;

    Abstract : For many metal components the presence of hard, non-metallic inclusions such as oxides lowers the impact toughness by acting as fracture initiation points and easing crack propagation. In components produced by powder metallurgy hot isostatic pressing (PM HIP), oxides often form a continuous network of small, spherical inclusions after consolidation at the prior particle boundaries (PPB). READ MORE

  6. 5. Property Optimization of PM-gearing

    University essay from KTH/Maskinkonstruktion (Inst.)

    Author : Marcus Söderberg Jansson; Oskar Lundkvist; [2017]
    Keywords : Gear; Powder Metallurgy; Property optimization; Egenskapsoptimering; Kugghjul; Pulvermetallurgi;

    Abstract : The purpose of this bachelor thesis is to design and optimize a powder metal gear through FEM-analyzes. The moment of inertia and weight of the gear shall be reduced at the same time as the demands on tension and bending stiffness are met. READ MORE