Essays about: "Selective Laser Melting SLM"
Showing result 1 - 5 of 22 essays containing the words Selective Laser Melting SLM.
-
1. Additively Manufactured Rare Earth Free Permanent Magnets
University essay from Uppsala universitet/Tillämpad materialvetenskap; Uppsala universitet/Oorganisk kemiAbstract : It’s well known that MnAl(C) material consists of a metastable phase (τ) with promising ferromagnetic properties, produced either by controlled cooling from the high-temperature hexagonal ε-phase or rapid cooling that freezes the ε-phase followed by low-temperature annealing. Due to the high cooling rates involved, additive manufacturing (AM) especially selective laser melting (SLM), has been identified as a possible method to retain the high-temperature ε-phase, hence containing a potential capacity to produce permanent magnets upon low-temperature annealing. READ MORE
-
2. Powder Rheology within AM production : Evaluating Compressibility, Permability, & Aeration for 316L Powders Within SLM Processes
University essay from Högskolan i Borås/Akademin för textil, teknik och ekonomiAbstract : Additive manufacturing with the use of metals have been a steadily increasing field, being able to create products with a higher degree of complexity than traditional processing techniques. SLM is a popular AM process that uses metal powder as feedstock, and one of the key components of this process is the powder rheology. READ MORE
-
3. The Effect Of Sub Tx Heat Treatments On The Magnetic Properties Of An Fe-based Bulk Metallic Glass
University essay from Uppsala universitet/MaterialfysikAbstract : Metallic glasses produced with Selective Laser Melting (SLM) often contain internal mechanic stress. This internal stress can have an impact on the magnetic properties of the material due to its connection to the magnetic anisotropy of the material. READ MORE
-
4. Experimental pressure loss analysis in a mini tube for a fully developed turbulent airflow. : Mini channels of lengths 22.5 mm to 150 mm in length with a constant diameter of 1.5 mm
University essay from Linköpings universitet/Mekanisk värmeteori och strömningsläraAbstract : The cooling systems in a gas turbine are especially important as the turbine blades and vanes are exposed to extreme temperatures. The relatively cool air is extracted from the compressors and fed to the turbines to cool the turbine blades. READ MORE
-
5. Mechanical and tribological characterization of additive manufactured Co-alloyed tool steels aimed for cutting tool bodies
University essay from Högskolan Dalarna/Institutionen för information och teknikAbstract : A drill tool body operates under tough cutting conditions where it is subjected to severe rubbing at the drill flute margin by the sliding chips. The tool wear caused by the contact stresses of the high-speed sliding chips is one of the common damage mechanisms observed in drill tool bodies. READ MORE