Essays about: "carbide wear"
Showing result 26 - 30 of 41 essays containing the words carbide wear.
-
26. Abrasive wear of hard faced ground engaging tool
University essay from KTH/Maskinkonstruktion (Inst.)Abstract : Ground engaging tools are very important components of machinery for agricultural applications, such as soil tillage. Ploughshare points serve as the first point of contact between ploughs and the hard minerals in the soil. READ MORE
-
27. Tool wear in turning of titanium alloy Ti–6Al–4V : Challenges and potential solutions for crater wear, diffusion and chip formation
University essay from Uppsala universitet/Tillämpad materialvetenskapAbstract : Titanium alloys are major materials used in the airplane industry, and prospects show that airplane production will double in the next 20 years. Consequently, the demand for cutting tools for machining of titanium alloys will increase. The primary problem when machining titanium alloys is their low thermal conductivity. READ MORE
-
28. Tribological testing of top hammer drill buttons
University essay from Uppsala universitet/Tillämpad materialvetenskapAbstract : In the present work further modifications are implemented to an existing test setup for the evaluation of the wear of cemented carbide drill buttons in rock drilling applications. The test setup has been evaluated in previous diploma works, which has shown that the test successfully mimics the wear seen in rock drilling applications. READ MORE
-
29. Machinability analysis of cemented carbide -A theoretical and experimental study
University essay from Lunds universitet/Industriell ProduktionAbstract : Sandvik Coromant is the market leader of producing tools for advanced metal cutting. The tools are produced in cemented carbide, however Sandvik Coromant does not produce tools for machining cemented carbide. READ MORE
-
30. Wear on Alumina Coated Tools and the Influence of Inclusions when Turning Low-Alloy Steels : Master Thesis - Chemical Engineering
University essay from Uppsala universitet/Tillämpad materialvetenskapAbstract : In this master thesis, performed at Sandvik Coromant Västberga (Stockholm), a comprehensive study has been made to investigate the wear on textured alumina (Inveio™) coated cutting tools when turning low-alloy steels. Specifically, wear studies have been made on tools’ rake faces when turning two separate batches of SS2541, after an initial turning time of 4 min. READ MORE