Essays about: "electrical characteristics"
Showing result 11 - 15 of 168 essays containing the words electrical characteristics.
-
11. Modelling and Simulation of Hydrogen Electrolyzers for Power System Applications
University essay from KTH/Skolan för elektroteknik och datavetenskap (EECS)Abstract : The rapid increase in the share of intermittent renewables in the energy mix is exacerbating the complexity of the grid stability. To facilitate the inclusion of these green technologies and achieve the climate targets set by the EU, the generation and storage of hydrogen through electrolysis may be crucial. READ MORE
-
12. Gate Drive Design for SiC MOSFET Device Characterization : Investigation into the impact of the gate inductance and resistance on the switching behaviour of SiC Power MOSFETs
University essay from KTH/Skolan för elektroteknik och datavetenskap (EECS)Abstract : Silicon Carbide as a wide-bandgap semiconductor has several physical and electrical advantages over Silicon for high voltage and high frequency applications. SiC as a MOSFET device has a lot of great characteristics like lower on-resistance and low input capacitances. READ MORE
-
13. Battery Storage as Grid Reinforcement for Peak Power Demands
University essay from Linköpings universitet/EnergisystemAbstract : An increased amount of intermittent electricity production, more electric vehicles (EV), and an overall electrification of society may all cause a higher variability between the balance of supply and demand on the electric grid. Battery storage has been identified as a solution to the emerging problem asit can be charged during hours of low power demand and then discharged to help meet the power demand during peak loads. READ MORE
-
14. The Influence of Roughness on Electrical Properties of Single Rock Fractures
University essay from KTH/Hållbar utveckling, miljövetenskap och teknikAbstract : To investigate the relationship between the structural characteristics of rough single fracturesand the electrical properties of the rock. In this study, a series of physical models of roughand smooth single fractures were established using the finite element method and Ohm's lawto test the electrical conductivity. READ MORE
-
15. Fabrication of sub-10 nm solid-state nanopores by electrical breakdown
University essay from KTH/Skolan för elektroteknik och datavetenskap (EECS)Abstract : Nanopore sensing is a versatile technique that employs very small openings, known as nanopores, to study biomolecules. The use of nanopores on solid-state membranes has gained attention due to its potential for low-cost and high-throughput sensing of single molecules in liquids. READ MORE