Essays about: "modulus of elasticity"
Showing result 1 - 5 of 46 essays containing the words modulus of elasticity.
-
1. Technical requirements for mooring goods in the Swedish Navy
University essay from KTH/HållfasthetsläraAbstract : The objective of this thesis is to generate and enhance technical specifications for mooring equipment designated for the Swedish Navy, as commissioned by the Swedish Defence Materiel Administration. The technical specifications will primarily emphasize the capacity to endure various load scenarios imposed by the Swedish Defence on the mooring equipment. READ MORE
-
2. Size effect in wood : Characterization of mechanical properties using digital image correlation method
University essay from Uppsala universitet/Tillämpad mekanikAbstract : As a natural composite material, wood exhibits complex structural char-acteristics and diverse behavior under compression and tensile forces. Itsanisotropic nature results in mechanical properties that vary depending onthe load direction along its longitudinal, tangential, and radial grains. READ MORE
-
3. Anisotropic Muscle Phantoms for Shear Wave Elastography Assessment of the Levator Ani Muscle Properties
University essay from KTH/Medicinteknik och hälsosystemAbstract : Pelvic floor disorder is an emerging research area and is highlighted in many pelvic floor studies. Assessment methods for this type of injury are lacking and new methods for prevention and diagnosis are needed. Pelvic floor disorders are common among women and can lead to suffering for the patient. READ MORE
-
4. Optimization of support in rock pillars between two parallel tunnels
University essay from KTH/Jord- och bergmekanikAbstract : When two parallel tunnels are excavated under high to moderate horizontal in-situ stresses combined with minor deformations in the pillar between the tunnels, the in-situ stresses can be redistributed over the tunnels in form of two compressive arches and are transferred from the roof to the abutments of the two tunnels. At additional deformations in the pillar, a new redistribution of the stresses can occur creating one compressive arch over both of the tunnels. READ MORE
-
5. Analysis of Resin Impregnated Non-woven : In collaboration with Hitachi Energy
University essay from Uppsala universitet/Institutionen för materialvetenskapAbstract : High voltage bushings are the most critical components of power transformers. A common material used in bushings is resin impregnated paper (RIP). Hitachi Energy is investigating whether this can be replaced with a new material, resin impregnated non-woven (RIN). READ MORE