Essays about: "steel edge beam"

Showing result 1 - 5 of 7 essays containing the words steel edge beam.

1. 1. Stabilisation of Steel Structures by Diaphragm Action of Trapezoidal Sheeting

   University essay from KTH/Bro- och stålbyggnad

   Author : Ondrej Novotny; [2020]
   Keywords : Diaphragm action; Stressed skin design; Trapezoidal sheeting; Corrugated sheet; Shear panels;

   Abstract : The main idea behind stabilisation by diaphragm action is to create a deep beam thatcan resist horizontal loads acting on a structure. It is achieved by connecting the sheetingto the primary structure of the roof so that the edge beams resist the bending momentthrough normal stresses and the sheeting resists the shear force through shear stresses. READ MORE

3. 2. Laser Hardening for Application on Crankshaft Surfaces Using Non-Uniform Beam Intensity Distributions

   University essay from Luleå tekniska universitet/Institutionen för teknikvetenskap och matematik

   Author : Victor Rönnerfjäll; [2019]
   Keywords : Laser transformation hardening; Crankshaft surface; Non-uniform beam intensity distributions; Hypoeutectoid steel; Microalloyed steel; 44MnSiVS6;

   Abstract : A controlled continuous laser output using a circular geometry with a gaussian intensity distribution was used to harden the surface of a particular metal specimen (44MnSiVS6). Said beam operated within a relatively small power interval, just barely past the melting point. READ MORE

4. 3. Phased Array Ultrasonic Testing of Austenitic Stainless Steel Welds of the 11 T HL-LHC Dipole Magnets

   University essay from Linköpings universitet/Institutionen för fysik, kemi och biologi

   Author : Marcus Lorentzon; [2018]
   Keywords : Phased Array Ultrasonic Testing; PAUT; Non-Destructive Testing; Austenitic Stainless Steel; Welds; CERN;

   Abstract : A routine non-destructive test method based on Phased Array Ultrasonic Testing (PAUT) has been developed and applied for the inspection of the first 11 T dipole prototype magnet half shell welds, and the test results are compared with the radiography and visual inspection results of the same welds. A manual scanner and alignment system have been developed and built to facilitate the inspection of the 5. READ MORE

5. 4. Development of a Bridge SteelEdge Beam Design : FE Modelling for a Vehicle Collision andCase Study

   University essay from KTH/Bro- och stålbyggnad

   Author : Diego Ramos Sangrós; [2015]
   Keywords : steel edge beam; collision analysis; edge beam development; bridge edge beam system; finite element modeling.;

   Abstract : The degradation of bridge edge beam systems in Sweden entailed the study of new alternativedesigns, which may become more optimal from a life-cycle perspective than the currenttypical solution used (concrete integrated). Subsequently, a U-shaped steel edge beamproposed by the consulting engineering group Ramböll was considered by the SwedishTransport Administration for its use in a real bridge project. READ MORE

6. 5. Compression perpendicular to grain in timber – Bearing strength for a sill plate

   University essay from Linnéuniversitetet/Institutionen för byggteknik (BY)

   Author : Ali Kathem; Tajdar Hussain; Arman Kamali; [2014]
   Keywords : bearing strength; sill plate; Eurocode 5; timber;

   Abstract : Timber is widely used in the construction industry, because of its availability and good properties. The compressive strength perpendicular to grain (bearing strength) is one property of wood which is important for structural design. The bearing strength is important for the behavior of the structure in all contact points between wooden members. READ MORE