Essays about: "track-and-hold"
Showing result 1 - 5 of 6 essays containing the word track-and-hold.
-
1. Design and Implementation of a high-efficiency low-power analog-to-digital converter for high-speed transceivers
University essay from Elektroniksystem; Tekniska högskolanAbstract : Modern communication systems require higher data rates which have increased thedemand for high speed transceivers. For a system to work efficiently, all blocks ofthat system should be fast. It can be seen that analog interfaces are the main bottleneckin whole system in terms of speed and power. READ MORE
-
2. Design of Highly Linear Sampling Switches for CMOS Track-and-Hold Circuits
University essay from Institutionen för systemteknikAbstract : This thesis discusses non-linearities associated with a sampling switch and compares transmission gate, bootstrapping and bulk-effect compensation architectures at circuit level from linearity point of view for 0.35 um CMOS process. All switch architectures have been discussed and designed with an additional constraint of switch reliability. READ MORE
-
3. High Speed On-Chip Measurment Circuit
University essay from Institutionen för systemteknikAbstract : This master thesis describes a design exploration of a circuit capable of measuring high speed signals without adding significant capacitive load to the measuring node. It is designed in a 0.13 CMOS process with a supply voltage of 1.2 Volt. READ MORE
-
4. Sampling Ocsilloscope On-Chip
University essay from Institutionen för systemteknikAbstract : Signal-integrity degradation from such factors as supply and substrate noise and cross talk between interconnects restricts the performance advances in Very Large Scale Integration (VLSI). To avoid this and to keep the signal-integrity, accurate measurements of the on-chip signal must be performed to get an insight in how the physical phenomenon affects the signals. READ MORE
-
5. Implementation and Evaluation of a RF Receiver Architecture Using an Undersampling Track-and-Hold Circuit
University essay from Institutionen för systemteknikAbstract : Today's radio frequency receivers for digital wireless communication are getting more and more complex. A single receiver unit should support multiple bands, have a wide bandwidth, be flexible and show good performance. To fulfil these requirements, new receiver architectures have to be developed and used. READ MORE
