Application of Dynamic Grouting to Improve the Grout Spread Using Varying Aperture Long Slot (VALS) : AN EXPERIMENTAL STUDY

Abstract: In the past centuries, grouting has been one of the most common techniques in geotechnical engineering to strengthen and seal underground structures. Concerning increasing demands for tightness and cost efficiency, cement-based grout has been one the most frequent used materials. One of the first grouting operations is the work done by Charles Bérigny in France back in 1802 in order to repair a sluice by stabilizing the ground with liquid grout. Several studies have been then conducted in grouting, which have contributed into successful improvement of the grouting operations. The investigations have also extended the understanding of the factors such as choice of materials, choice of equipment, and the applied pressure type and magnitude, etc. that influencing the grout spread in rock fracture systems.   Among the factors, the applied pressure is one of the most significant ones influencing the spread of grout during grouting operations. Grouting at static pressure conditions is the most common method used in field, where in practice the injected grout can only penetrate into the rock fractures wider than 100 µm.   Recent investigations conducted on application of static and dynamic pressure conditions, using Short Slot and Varying Aperture Long Slot (VALS) in the lab have yielded an overall improvement of the grout spread under dynamic pressure conditions rather than the conventional static pressure conditions. However, the efforts conducted are just a beginning, especially in very fine micro factures smaller than 70 µm    The main objective of this investigation was therefore to improve the spread of grout by dynamic grouting into fractures smaller than 70 µm effectively, which could not be done with grouting at static pressure conditions.  Furthermore, the aim was to investigate filtration and erosion phenomena/ tendency of grout flow during static and dynamic pressure application using Varying Aperture Long Slot (VALS) in the lab. The durations of peak and rest periods used in the experiments were 2s/2s and 1s/5.5s, which were equivalent to 0.25 Hz and 0.15 Hz, respectively. The results of dynamic grouting showed up to 10 times improvement in the volume of passed grout through fracture apertures smaller than 70 µm.