Electrolytic Extraction of Aluminium Bifilms

Abstract: Bifilms is the oxide layer created between two surfaces in the melt of light metals that form an oxide layer. These become planar inclusions in the final casting and are problematic for the mechanical properties such as cracks and crack initiations. Bifilms are too thin to be viewed properly in two dimension cross-section method as they will only appear as thin lines. Because of this, it is relevant to test if it is possible to use electrolytic extraction (EE) as a alternative method to investigate bifilms. Both the deeply etched surface and the inclusions on a filter from the extraction are looked at in the scanning electron microscope (SEM) to get an understanding of the size and shape of the inclusions. With this, a greater understanding of these types of defects can be achieved. After both the filtered inclusions and the surface are examined in SEM with images and Energy-dispersive X-ray spectroscopy (EDS), the images are measured in the software ImageJ. The measurements and analysis show that it is probably bifilms and that they can be relatively large, and not so circular. However, the measurements with the filter have shown high levels of oxygen and carbon. Some levels of chlorine, nitrogen and iron have also been found. But if the surface is compared to the metal surface, it can be concluded that it is likely that bifilms have been found. There are sufficient levels of aluminum and oxygen present. Images in SEM also show the appearance of film-like inclusions. If the method of electrolytic extraction is to be improved to investigate bifilms,optimizations such as filters of other compositions are recommended.