Essays about: "ANSYS impact"

Showing result 26 - 30 of 38 essays containing the words ANSYS impact.

1. 26. Numerical Analysis ofLatent Thermal Energy Storage in a Cavity

   University essay from KTH/Energiteknik

   Author : Robert Olrog; [2017]
   Keywords : ;

   Abstract : Latent Thermal Energy Storage (LTES) has drawn attention because the technology is a simple and cost-efficient method to store large amounts of energy. Latent energy is either stored or released when the material inside the LTES undergoes phase-change. READ MORE

3. 27. Numerical Analysis of Latent Thermal EnergyStorage in Coaxial Component

   University essay from KTH/Energiteknik

   Author : Hampus Nilsson; [2017]
   Keywords : ;

   Abstract : Latent Thermal Energy Storage, LTES, is a system for storing energy for later use. It isused in applications such as buildings, electronics and space shuttles. The problem associatedwith the system is the relatively low charging and discharging power i.e. READ MORE

4. 28. Ambient Air Quality in Parking Locations and how to Improve it

   University essay from Luleå tekniska universitet/Institutionen för teknikvetenskap och matematik; Luleå tekniska universitet/Institutionen för system- och rymdteknik

   Author : Henrik Johansson; Kristofer Sellberg; [2016]
   Keywords : CFD; computational fluid dynamics; PM; particle matter; VIT; vehicle induced turbulence; UFP; ultra fine particle;

   Abstract : This thesis has two major purposes: (1) to investigate the impact carshave on Particulate Matter (PM) level in a limited area and (2) to demonstratethrough Computational Fluid Dynamics (CFD) the possibility toclean a limited area of PM with a system installed on a car.This thesis was performed in collaboration with Volvo Car Corporation(VCC) at Torslanda, Göteborg. READ MORE

5. 29. Evaluation of design and optimization software for Additive Manufacturing with focus on topology optimization

   University essay from KTH/Industriell produktion

   Author : DIEGO DELLA CROCIATA; [2016]
   Keywords : ;

   Abstract : During the past years, new production processes have been developed which build adding step by step layers on the previous ones. These techniques are referred to as 3D printing or Additive Manufacturing (AM). The introduction of metals among the materials available to manufacture parts led to revolutionary developments in the manufacturing field. READ MORE

6. 30. Material selection for an aerospace component

   University essay from KTH/Lättkonstruktioner

   Author : Gustav Jönsson; [2015]
   Keywords : ;

   Abstract : In the world of today there is a drive for lighter and more effective products for various reasons e.g. reduced environmental impact, higher payload, fuel efficiency etc. There is also an expanding development of new materials for a large number of different applications. READ MORE