Optimization of the performance ofdown-draft biomass gasifier installedat National Engineering Research &Development (NERD) Centre ofSri Lanka

University essay from KTH/Kraft- och värmeteknologi

Abstract: Using biomass gasification to produce combustible gas is one of the promising sustainable energy optionsavailable for many countries. At present, a few small scale community based power generation systemsusing biomass gasifiers are in operation in Sri Lanka. However, due to the lack of proper knowledge, thesesystems are not being operated properly in full capacity. This stands as an obstacle for further expansionof the use of gasifier technology.The objective of this study was to identify the most influential parameters related to fuel wood gasificationwith a down draft gasifier in order to improve the gasification processes.A downdraft gasifier of 10kW electrical capacity was used to study the effect of equivalent ratio (Actual airfuel ratio to Stoicheometric air fuel ratio: ER) on the specific gas production, the heating value of gasproduced and the cold gas efficiency using three throat diameters (125mm, 150mm and 175mm). Six trialswere carried out for each throat diameter by varying the supply air flow to change the ER. The gassamples were tested for their compositions under steady state operating conditions. Using mass balancesfor C and N, the cold gas efficiencies, calorific values and the specific gas production rates weredetermined.The results showed that with all throat diameters the calorific value of gas reduced with the increase ofER. The cold gas efficiency reduced with ER in a similar trend for all three throat diameters. The specificgas production increased with ER under all throat diameters.Calorific value and specific gas production are changing inversely proportional manner. The ER to beoperated is depends on the type of application of the gas produced and engine characteristics. When alarge heat is required, low ER is to be used in which gas production is less. In the opposite way, when alarge amount of gas is needed, higher value of ER is recommended.

  AT THIS PAGE YOU CAN DOWNLOAD THE WHOLE ESSAY. (follow the link to the next page)