Essays about: "melt fraction"
Showing result 1 - 5 of 16 essays containing the words melt fraction.
-
1. Syn-Magmatic Deformation Structures in the Slaufrudalur Pluton, East Iceland
University essay from Uppsala universitet/Institutionen för geovetenskaperAbstract : Structures and deformation mechanisms of magmatic rocks are controlled by rheology. An increase in melt fraction can weaken a rock body and localises significant amount of strain. This interplay between rheology, melting and deformation in a magma reservoir, however, is not always clearly documented in literature. READ MORE
-
2. Investigation of new hot melt adhesives with plasticisers based on renewable resources : Investigating the use of sustainable plasticisers in hot melt adhesives
University essay from Karlstads universitet/Institutionen för ingenjörs- och kemivetenskaper (from 2013)Abstract : Hot melt adhesives (HMA) are a class of adhesives that, unlike solvent-or waterborne counterparts, do not contain organic solvents or other carriers, and are produced and subsequently applied in a molten state. The main components of HMA are polymers, tackifying resins, and a plasticiser. READ MORE
-
3. Apparent density for water atomized low-carbon steel powder
University essay from KTH/MaterialvetenskapAbstract : Carbon content does not affect the apparent density for water atomized iron powder monotonically. At low carbon content, around 0.1 wt %, apparent density is higher than a similar powder with 0.3 wt % carbon. READ MORE
-
4. Monitoring of heat exchanges in thesnowpack of Foxfonna glacier, Spitzbergen,Svalbard.
University essay from Lunds universitet/Förbränningsfysik; Lunds universitet/Fysiska institutionenAbstract : The processes of meltwater storage in firn and the impact of refreezing on firn-coveredglaciers have been investigated on the Greenland ice-sheet. On Svalbard, climate changepromotes the disappearance of firn on glaciers. READ MORE
-
5. Influence of Rheocasting process conditions on microstructural properties of A356 alloy and slurry yield behaviour
University essay from Jönköping University/JTH. Forskningsmiljö Material och tillverkning – GjutningAbstract : Recent decades have attracted board interest in the Rheocasting process. The High demand for lightweight, strong alloys and complex design parameters involves challenges in maintaining cost-effectiveness and energy consumption. READ MORE