Essays about: "Coriolis"
Showing result 1 - 5 of 8 essays containing the word Coriolis.
-
1. Fuel consumption measurements and fuelconditioning in high-pressure fuel systemfor single cylinder test cell
University essay from Karlstads universitet/Fakulteten för hälsa, natur- och teknikvetenskap (from 2013)Abstract : This master thesis is part of a bigger project issued by AVL with the purpose to design a high pressure compression ignition fuel system for their single cylinder test cell at their facility in Södertälje. Typically compression-ignition fuel tests are being run within an operating pressure range of 500-2400 bar, but this system has to be able to run with pressures up to 3500 bar. READ MORE
-
2. Sensorless collision detection with safe reaction for a robot manipulator.
University essay from KTH/Skolan för industriell teknik och management (ITM)Abstract : This thesis is about collision detection and reaction for robot manipulators without joint torque sensors. The method for detecting collisions used by [1], [2] is based on an algorithm that estimates the residual torque i.e. READ MORE
-
3. Evaluation and optimization of PolyCor - a single-use Coriolis flowmeter
University essay from Umeå universitet/Institutionen för fysikAbstract : In the pharmaceutical industry it has become common to use single-use components in the production line to save time and money. Therefore, a team at General Electric started to develop a single-use Coriolis flowmeter, PolyCor M13, targeted at liquid chromatography systems. READ MORE
-
4. Modelling the Formation and Propagation of Orographic Rossby Waves
University essay from Uppsala universitet/Luft-, vatten- och landskapsläraAbstract : Orographic Rossby waves are the main mechanism by which the jet streams meander aroundthe Earth and have possibly far-reaching impacts on weather and climate (chapter 1). Hence,they are of particular importance to study and this project should serve as a starting point inwhat to consider when trying to model these waves. READ MORE
-
5. Velocity estimation in land vehicle applications - Sensor Fusion using GPS, IMU and Output-shaft
University essay from KTH/Optimeringslära och systemteoriAbstract : In this project an alternative velocity-signal for Scania’s heavy-duty vehicles was investigated. The current velocity estimation is based on wheel-encoders obtained from other control-units like ABS- and EBSsystems. Furthermore the wheel-encoders may have poor properties at both high and low velocites. READ MORE