Advanced search
Showing result 1 - 5 of 6 essays matching the above criteria.
-
1. Classification of Flying Qualities with Machine Learning Methods
University essay from KTH/FlygdynamikAbstract : The primary objective of this thesis is to evaluate the prospect of machine learning methods being used to classify flying qualities based on simulator data (with the focus being on pitch maneuvers). If critical flying qualities could be identified earlier in the verification process, they can be further invested in and focused on with less cost for design changes of the flight control system. READ MORE
-
2. Influence of Design Parameter Variation on Fighter Agility Metrics
University essay from KTH/FlygdynamikAbstract : Metrics that quantify fighter aircraft performance is an active research topic, and agility metrics seek to measure performance previously not captured with classic point performance metrics. Agility metrics are researched to be used in analysis with an advanced desktop simulator and investigate the effects of design parameter variation. READ MORE
-
3. Methodology For Evaluating Flying Qualities From Desktop Simulator
University essay from Luleå tekniska universitet/RymdteknikAbstract : A modern ghter aircraft has an advanced ight control system which highly augmentsthe control inputs from the pilot. To verify a new iteration of the control system is a timeconsuming and expensive task. READ MORE
-
4. Realization of a serially-linked haptic device
University essay from KTH/Maskinkonstruktion (Inst.)Abstract : Spatial haptic interfaces have existed for more than 20 years but have not been widespread despite promising applications. The few devices found in the market as of today are either considered costly, of higher quality and produced in smaller series or mass-produced and cheap, but of lower quality. READ MORE
-
5. Enhancement of the Mechatronic Development Process with Software in the loop Simulation : An embedded control case study
University essay from KTH/Maskinkonstruktion (Inst.)Abstract : This master thesis is performed at the mechatronic department at the company Mycronic, which are responsible for the embedded software in their pick and place machines. Today the embedded code can be executed and tested on a PIL simulation, where the control code runs on the actual target processor and the dynamic of the system (plant model) is modeled by a mathematical equation implemented as a C-function on the target board. READ MORE