Essays about: "Legering"
Showing result 1 - 5 of 32 essays containing the word Legering.
-
1. Tuning Photovoltaic Properties of Two-dimensional Molybdenum Disulfide by Alloying: An ab initio study
University essay from KTH/MaterialvetenskapAbstract : Addressing the urgent need for innovative energy solutions amidst increasing environmental concerns, the focus on photovoltaic solar cells is intensifying. Currently limited by the Shockley-Queisser limit, conventional silicon-based solar cells offer a maximum power conversion efficiency of 32%. READ MORE
-
2. Precipitation analysis in bearing steel Hybrid 60
University essay from KTH/MaterialvetenskapAbstract : New materials are always being developed to get the best properties possible where needed. The way to create these materials and test them is also developing. When it comes to high-strength steels, a martensitic microstructure is a common choice. READ MORE
-
3. Effect of dwell (hold) time on high temperature fatigue crack growth of AM components
University essay from KTH/Lättkonstruktioner, marina system, flyg- och rymdteknik, rörelsemekanikAbstract : GKN Aerospace AB, Sweden (GAS) is one of the leading companies taking up the charge in manufacturing components using Additive Manufacturing(ed) (AM) techniques in the aerospace sector. They are a hub of engineering and they are a supplier of engine and engine components to the world’s leading aero-engine manufacturers, and airframes to civil and military aircraft manufacturers. READ MORE
-
4. Dependence of Degradation Mechanisms in Magnesium Alloys on Grain Orientation and Interfaces in 3D
University essay from Lunds universitet/MaterialteknikAbstract : Magnesium alloys are promising candidates as biomedical implants. However, a good understanding of their degradation processes is lacking. In this work, degradation in two magnesium alloys were studied in a simple physiological-fluid electrolyte of H2O+0.9wt%NaCl, Mg-5wt%Zn (Z5) & Mg-5wt%Zn-0. READ MORE
-
5. Optimization of the process-route of a Nickel-base alloy : Investigation of Sigma-phase precipitation in heat treatment
University essay from Karlstads universitet/Fakulteten för hälsa, natur- och teknikvetenskap (from 2013)Abstract : The focus of this master’s thesis is on the heat treatment of Ni-base alloys, specifically the risk of intermetallic σ-phases during different stages of heat treatment. The alloy studied is Sanicro®28, a super-austenitic stainless steel produced by Alleima AB. READ MORE