Essays about: "austenitiskt rostfritt stål"
Found 5 essays containing the words austenitiskt rostfritt stål.
-
1. Optimization of the process-route of a Nickel-base alloy : Investigation of Sigma-phase precipitation in heat treatment
University essay from Karlstads universitet/Fakulteten för hälsa, natur- och teknikvetenskap (from 2013)Abstract : The focus of this master’s thesis is on the heat treatment of Ni-base alloys, specifically the risk of intermetallic σ-phases during different stages of heat treatment. The alloy studied is Sanicro®28, a super-austenitic stainless steel produced by Alleima AB. READ MORE
-
2. Analysis of headbox structural strength : OptiFlo II TIS 2200
University essay fromAbstract : Valmet is a world leading supplier of tissue machines. In the tissue industry the demand on the machines is high to be able to produce the finest paper for use in products such as toilet paper and napkins. The machine components need to perform to be able to produce a product of consistent quality. READ MORE
-
3. Evaluation of current welding robot and improvement proposals for future use
University essay from KTH/Marina systemAbstract : Welding of elements, a heat exchanging component, is one of the most essential processes during the manufacturing of Tubel evaporators. Weld joints consists of fillet welds of thin tubes against a plate on one end, and on the other end against a thicker pipe with entry holes for the tubes. READ MORE
-
4. Consequences of Magnetic Properties in Stainless Steel for a High-efficiency Wave Power Generator
University essay from KTH/Hållbar utveckling, miljövetenskap och teknikAbstract : A new kind of wave power generator is being developed at KTH Royal Institute of Technology which potentially can reach an efficiency of 98 %. However, this generator’s small air gap sets strict requirements on the stiffness of the structure to withstand the large magnetic forces. The structure, therefore, need to be both stiff and non-magnetic. READ MORE
-
5. Built-up edge formation in stainless steel milling
University essay from KTH/MaterialvetenskapAbstract : Milling tests were performed in stainless steel to investigate the formation of built-up edge (BUE). Three variants of tests were conducted which were divided as high-, medium, and low temperature milling tests. These tests were run in the austenitic stainless steel SS2343. READ MORE