Essays about: "conversion coatings"
Showing result 1 - 5 of 6 essays containing the words conversion coatings.
-
1. Short wavelength UV–LED photoinitiated radical polymerization of acrylate–based coating systems—A comparison with conventional UV curing.
University essay from Uppsala universitet/StrukturkemiAbstract : The present work was performed at Sherwin–Williams Sweden group AB with the objective of comparing short-wavelength light emitting diodes (UVB/UVC) with the conventional mercury arc lamp as a curing method of acrylate-based, UV-paint undergoing free-radical polymerization when exposed to UV-radiation. Due to environmental and health risks, mercury-doped radiation sources will be phased out in the near future, according to the United Nations Minamata convention, hence new alternatives are needed. READ MORE
-
2. Sn-Pb-mixtures for Perovskite Solar Cells
University essay from Lunds universitet/Fasta tillståndets fysik; Lunds universitet/Fysiska institutionenAbstract : Perovskite research has quickly gone from non-existent to one of the biggest reseach areas in Photo- voltaics. There are still many questions to be solved regarding the stability, environmental impact, reproducible large area devices, efficiency and module fabrication cost of Perovskite Solar Cells, PSCs, before commercial up-scaling. READ MORE
-
3. Development of Novel (Cu,Fe)3O4 Coatings for AISI 441 Solid Oxide Cell Interconnects : Coating optimization and long-term study
University essay from KTH/MaterialvetenskapAbstract : As current environmental challenges are gaining increased attention, development of clean energy solutions is becoming one of the essential strategies to keep within the boundaries of established environmental policies. Solid oxide cell (SOC) technology can provide clean energy conversion and storage when hydrogen is the energy carrier. READ MORE
-
4. Analysis and characterization of environmental friendly trivalent chromium passivation of aluminum alloys
University essay from Linköpings universitet/Institutionen för fysik, kemi och biologiAbstract : As of 21st September 2017, industrial use of hexavalent chromium (Cr(VI)) will, due to its environmental toxicity and carcinogenicity, be restricted by REACH regulations. Saab Aeronautics is therefore shifting anticorrosion surface treatment of aluminum alloys from hexavalent chromium conversion to trivalent chromium (Cr(III)) passivation. READ MORE
-
5. Characterisation of the influence of curing temperature on the properties of 2K waterborne topcoat
University essay from KTH/KemiAbstract : Replacing solventborne coating with waterborne can reduce emission of VOC from paint shops, and decrease the amount of CO2 released from after-burners. The chemistry of 2K WB urethane coatings includes complex kinetics, with a selectivity which is highly dependent on application and curing conditions. READ MORE