Essays about: "flank wear"

Showing result 11 - 13 of 13 essays containing the words flank wear.

  1. 11. Estimation of flank wear growth on coated inserts

    University essay from Institutionen för fysik och astronomi

    Author : Mushtaq Ahmad Latifzada; [2013]
    Keywords : Tribology; flank wear; abrasive wear; cutting force; Cemented carbide;

    Abstract : The present work was conducted in Sandvik Coromant to enhance the knowledge and understanding of general flank wear growth and specifically in this case flank wear growth on the cutting edge of the coated (Ti(C, N)/ Al2O3/ TiN) tool inserts.   Reliable modeling of tool life is always a concern for machining processes. READ MORE

  3. 12. Optimization of cutting parameters in machining of Compacted Graphite Iron (CGI)

    University essay from KTH/Industriell produktion

    Author : Mulugeta Berhane; [2011]
    Keywords : Compacted Graphite Iron CGI ; face milling; tool life; MRR; optimization; cutting force;

    Abstract : Compacted Graphite Iron offers mechanical properties in between of gray cast iron and ductile iron. Thus,the material is seen as a hopeful alternative for engine cylinder blocks and heads satisfying environmentaland performance objectives. READ MORE

  4. 13. The effect of prior austenite grain size on the machinability of a pre-hardened mold steel. : Measurement of average grain size using experimental methods and empirical models.

    University essay from Avdelningen för maskin- och materialteknik

    Author : Muhammad Aatif Irshad; [2011]
    Keywords : prior austenite grain size; machining; mold steels; pre-hardened mold steels; work hardening; retained austenite; metallography; tool steels; chemical etching; prior austenite grains; lath martensite; rough machining; finish machining; Metallographic specimen preparation; Austenite grain growth; cutting tool; cutting tool life; wear; Theoretical average chip thickness;

    Abstract : The use of pre-hardened mold steels has increased appreciably over the years; more than 80% of the plastic mold steels are used in pre-hardened condition. These steels are delivered to the customer in finished state i.e. there is no need of any post treatment. READ MORE