Essays about: "beam theory analysis"

Showing result 6 - 10 of 33 essays containing the words beam theory analysis.

  1. 6. Design Study of Welded Beam Bracket According to Stress Concentrations in the Weld

    University essay from KTH/Skolan för industriell teknik och management (ITM)

    Author : FREDRIK EKLUND; [2021]
    Keywords : Plug weld; slot weld; welded beam; welded beam bracket; welded bus chassis; Pluggsvets; svetsad balk; svetsad busschassi; svetsad ram;

    Abstract : In a bus chassis, welded connections are often preferred to other fastening techniques due to low cost and broad competence among suppliers but are usually the weakest parts due to fatigue life. Evaluation of welds is often costly in time and competence. READ MORE

  3. 7. Enhancing the endurance of UAVs by the use of structural power composites: System-level study of a flying wing

    University essay from KTH/Lättkonstruktioner

    Author : Gustav Burman; [2021]
    Keywords : ;

    Abstract : This thesis studies the feasibility of integrating the novelStructural Battery (SB)[1] into the airframe of a UnmannedAerial Vehicle (UAV). The potential advantages in terms ofmass, range and endurance are studied.The aircraft performance is analysed using conventionalflight mechanics, modelled in Matlab and Xfoil. READ MORE

  4. 8. Micro-architectured materials for noise and vibration control in high voltage products – design and modelling

    University essay from Uppsala universitet/Tillämpad mekanik

    Author : Alec Chamberlain; [2021]
    Keywords : Microarchitectured; lattice; elasticity; viscoelasticity; computational; homogenization;

    Abstract : Many Hitachi ABB Power Grids (HAPG) products vibrate and emit noise, but legal limitations of these parameters fuel the development of energy absorption methods used on products. Methods such as Constrained Layer Damping (CLD). READ MORE

  5. 9. Designing of One Directional Wave Tank

    University essay from Uppsala universitet/Institutionen för elektroteknik

    Author : Shivansh Ringe; [2020]
    Keywords : Wave tank; Ansys Fluent; SolidWorks; CFD; Design;

    Abstract : Uppsala University wants to make a wave tank which can be used for experiment and education purpose. The project's aim is to get design parameters required to make a wave tank, design the wave tank, to do analysis on wave parameters taken from results and analysis of material which can be used to construct it. READ MORE

  6. 10. Computational modeling strategy of steel connections

    University essay from Lunds universitet/Institutionen för byggvetenskaper; Lunds universitet/Byggnadsmekanik

    Author : Carl-Michael Bjälkensäter; Carl Holmgren; [2019]
    Keywords : FEM; steel; connection; joint; Technology and Engineering;

    Abstract : When designing large complex steel structures numerical calculation methods are always used to some extent. The simulation technology of today is advanced and can with proper modeling technique provide detailed analyses which captures the structural response accurately. READ MORE