Essays about: "fault tree analysis"
Showing result 6 - 10 of 32 essays containing the words fault tree analysis.
-
6. Fault Tree Analysis of Quick Clay Slides
University essay from KTH/Jord- och bergmekanikAbstract : Quick clay slides are quite rare but often leads to major consequences for the society. These type of slides are complex and the true causes leading to a slide is difficult to map since the evidence is destroyed during the slide. Because of this, different theories develop of the causes of the slide based on the same information. READ MORE
-
7. Development of Reliability AnalysisTool to Study Tribology in WindTurbines
University essay from KTH/Skolan för industriell teknik och management (ITM)Abstract : Wind energy is one of the most promising sources of renewable energy. Unfortunately, therapid growth in wind turbine technology is not equally at par with the improvement in itsreliability. Wind turbine systems tend to fail before their design life and hence result in asizeable amount of failure cost. READ MORE
-
8. Safety solution for the powerlifting squat : Improving the safety for lifters and spotters in competition
University essay from Luleå tekniska universitet/Institutionen för ekonomi, teknik och samhälleAbstract : In powerlifting the athletes compete to lift as much weight as possible in the squat, bench press and deadlift, pushing their bodies to extreme levels of strength. When lifting heavy weights, safety becomes an important concern, especially where the lifters can get injured by the barbell if a lift is unsuccessful. READ MORE
-
9. DEVELOPMENT OF RISK INFORMED METHODS FOR ESTIMATING RADIATION RELEASE FROM CABLE FIRES AT HIGH ENERGY PHYSICS FACILITIES
University essay from Lunds universitet/Avdelningen för BrandteknikAbstract : CERN operates the Large Hadron Collider (LHC), the world’s largest and most powerful particle accelerator. The LHC was built to advance the state of knowledge in particle physics by increasing the energy of colliding particles to the TeV range. READ MORE
-
10. Redesigning the production system at the crossmember painting line
University essay from Luleå tekniska universitet/Institutionen för ekonomi, teknik och samhälleAbstract : This master thesis was performed in collaboration with Scania Ferruform in Luleå, with the purpose to create an efficient, rational and safe workplace at the unloading station of the crossmember painting line. The mission from Ferruform was to investigate and analyse flaws, risk, and bottlenecks with regards to flows, ergonomics and material handling. READ MORE