GC-MS Screening and PCB Analysis of Sediment from Central Kattegat

Abstract: Five sediment samples were collected in Bua on the Swedish west coast, near two industries, a paper mill, and a nuclear power plant. The two industries use water in their processes and have long been associated with releases of different substances, such as PCBs, and other chlorinated compounds. The environmental impact by the two industries is believed to be significant. The aim of the project was to examine the sediments close to both the water intake and water output to determine if these industrial activities have in any way changed the composition of the sediments. The sediments were extracted by Soxhlet extraction, followed by a deactivated silica and an acidic silica clean-up and then analysed by using a gas chromatograph coupled to a mass spectrometer, (GC-MS) with electron ionization, EI+, mode used in full scan mode. Each mass spectra were analysed by comparing them to the NIST database from 1998. The results were inconclusive since the peaks were not properly resolved, causing a poor correlation to the NIST database. One batch was specifically analysed for polychlorinated biphenyls (PCB) by using an atmospheric pressure gas chromatograph (APGC) coupled to a mass spectrometer (MS). The PCB analysis provided accurate results, except for the Ringhals intake where the MS became saturated due to the high levels. The river Viskan also showed high levels of PCB. The congener pattern from PCBs found near Ringhals intake resembled an Aroclor pattern from Aroclor 1248. Since the Aroclor pattern is only seen in Ringhals intake, the source is most likely from the small harbour and not from either of the industries.