Essays about: "jet in time"
Showing result 11 - 15 of 116 essays containing the words jet in time.
-
11. Risk of fragment hit on aircraft after releasing a bomb
University essay from KTH/Lättkonstruktioner, marina system, flyg- och rymdteknik, rörelsemekanikAbstract : An aircraft is exposed for a certain risk during warhead deployment. If the distance is too short between the aircraftand warhead during burst, fragments may hit the aircraft with fatal consequences. The warhead consists not onlyof fragments created during burst but also parts to attach it to the aircraft such as mounting plates and fasteningloops. READ MORE
-
12. Weight Prediction of the Environmental Control System for Fighter Aircraft
University essay from KTH/Lättkonstruktioner, marina system, flyg- och rymdteknik, rörelsemekanikAbstract : Aircraft design is heavily reliant on weight characteristics of the vehicle, and predicting the weight of subsystems in an early design phase is fundamental. The problem with predicting the weight of aircraft subsystems today is that the number of input parameters do not represent enough level of accuracy to account for different architectural solutions. READ MORE
-
13. Flying through cometary jets with the Rosetta spacecraft
University essay from Uppsala universitet/Institutionen för fysik och astronomi; Uppsala universitet/Institutet för rymdfysik, UppsalaavdelningenAbstract : The Rosetta spacecraft orbited around comet 67P/Churyumov-Gerasimenko from 2014 to 2016. During this time, several thousands of cometary jets occurred and were photographed by the onboard cameras. READ MORE
-
14. Autoencoder Compression in High Energy Physics
University essay from Lunds universitet/Partikel- och kärnfysik; Lunds universitet/Fysiska institutionen; Lunds universitet/Lunds Tekniska HögskolaAbstract : Situated in Geneva, Switzerland, the Large Hadron Collider is largest particle accelerator in the world, and as such, its operation carries with it some of the greatest technical challenges ever faced. Among them are the huge demands put on data storage capacity by experiments in particle physics, both in terms of rate and volume of data. READ MORE
-
15. Additive Manufacturing of Strain Gauges : A Study of the Feasibility of Printing Strain Gauges Using Inkjet Printing
University essay from Uppsala universitet/Institutionen för materialvetenskapAbstract : Additive manufacturing (AM) also commonly known as 3D-printing is a manufacturing method which creates parts from adding layer into another. In the field of printed electronics Inkjet printing (IJP) and Aerosol Jet printing (AJP) are the most common AM techniques. READ MORE